starting the plumbing of the brewery.

Cut the water pipe from kitchen sink and added a Y.

PVC and Copper pipe work.

Started fitting waste pipe from the pump.

Mash tun cooler conversion

I did bend the "false bottom" it was and still not seating tight on the bottom, the tube in the middle was a pain to install, the ball valve had to go after the "FB" .

below the weldless ball valve

Home made mash paddle

I made the paddle the simple way , I do not have a drill press,  so I had to keep it simple, the wood is pine, I will boil the paddle for 20 minutes or so to remove any tannin, I might even char the top layer after, the wood does not smell, so I am assuming it is not going to leash wood flavors in the mash.

dimension 36" long, 3/8" for the main stick, and 1/2 for the rake.

The tail is glued and tied with a copper wire.

The rake are also pine,

  I also rounded the tip.

My brewery - contruction

extractor, fridge for yeast, raised faucet,extractable table (square

on the wall),

  

Gray water pump (cylinder by sink), faucet was raised by 2X4's to have enough clearance for carboys and bucket washing

 

Square on the wall will be a retractable table ( small ) for mash tun

 

Duct work with extractor 150 CFM (filter will be removed on full boils)

 

also making magnet out of breweries caps ( above) on the top the finished ones and on the bottom jut the magnet for now